Function to be activated via VCDS - VAG-COM software
Option description:
Allows you to recalibrate the reference height of the electronically controlled suspension to the original values.
Audi Q7 (4L): 449 mm (front) and 465 mm (rear)
The gear selector must be in neutral (manual transmission) / in the "P" position (automatic transmission)
Start the engine; it must run for the entire duration of the calibration. Do not turn off the ignition.
All doors must be closed and not opened during calibration.
Actual height measurement of the suspensions
It is necessary to measure and note the actual height of each suspension.
Suspension height is the vertical distance between the center of the wheel and the lower edge of the fender at the wheel arch.
Calibration
[34 – Correct. plate] -> [Security Access – 16] 31564
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 01
Left front suspension adjustment
Enter the previously measured value
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 02
Right front suspension adjustment
Enter the previously measured value
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 03
Left rear suspension adjustment
Enter the previously measured value
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 04
Right rear suspension adjustment
Enter the previously measured value
[34 – Correct. plate] -> [Security Access – 16] 31564 -> [Adaptation – 10] -> Channel 05
Set the value to 1
